Reasons to Buy 2002-2006 Nissan Altima Keyless Entry Remote Key Fob w/ Free DIY Programming Instructions

Product Description

Replacement 4 Button Remote w/ Free Do It Your programming
Unlimited free tech support.

Product Details

• Amazon Sales Rank: #224 in Automotive
• Brand: Nissan Infiniti
• Model: ASTU15 / Dealer part # 28268-ZB700
• Dimensions: .13 pounds

Features

• SAFETY
• SECURITY
• CONVENIENCE
• REMOTELY LOCK & UNLOCK DOORS
• REMOTELY ACTIVATE PANIC ALARM & TRUNK RELEASE

Customer Reviews

Most helpful customer reviews

41 of 42 people found the following review helpful.
I works and feels like the original
By jasenjude
I honestly thought this would be total crap and took the chance anyway and THEY WORK GREAT. They look and feel like the original, too. I purchased 2 of these remotes for my 02 Altima and googled for the programming instructions. I found this site [...] and followed the instructions. I pasted the necessary steps below. Note: I did have to replace one of the remote batteries almost immediately, no stars off for that. He gets 5 stars for price-quality ratio

ID Code Entry Procedure

To enter the ID code, follow this procedure:

"Setting Mode":

1. Close and lock all doors.
2. Insert and remove the key from the ignition more than six times within 10 seconds. (The hazard warning lamp will flash twice). At this time, the original ID codes are eliminated.

ID Code Entry:

3. Turn ignition key to "ACC" position
4. Push the "lock" button on the new remote control once(for example, if the door is locked using the remote controller during this ID code entry state, a new ID code can be entered). At this time, the new ID code is entered. (The hazard warning lamp will then flash twice).

Additional ID code Entry:

5. If you need to activate additional remote control units, unlock the drivers door, then lock it again(WITH THE DOOR LOCK SWITCH).
6. Push the lock button on the additional remote once.
7. This ID code enable state and setting mode will remain until the drivers door is opened.

NOTE!!

* If you need to activate more than two additional keyless remotes, repeat the procedure "Additional ID code entry" for each new remote.

* If the same ID code that exists in the memory is input, the hazard warning lamps will flash twice but the entry will be ignored.

*Entry of a maximum of four ID codes is allowed and any attempt to enter more will be ignored.

*Any ID codes entered after termination of the "Setting Mode" will not be accepted. Additional keyless remote signals will be inhibited when an ID code has not been entered during the setting mode.

10 of 10 people found the following review helpful.
Well worth the money - easy setup!
By egiles
I normally do not write reviews. This product was shipped quickly with very easy to follow instructions. I took it out of the mailbox and immediately was able to set the remote with no problems. The directions were very simple.

5 of 5 people found the following review helpful.
Great product at a great price.
By james w matthews
comes with instructions 1 min and your done with programming.
Amazed so cheap and so GOOD.
Now if I could just remember where I put my keys.

See all 318 customer reviews...